第五步：完全移出后，切下三个刀片，取出两段符合要求的产品。当爪被释放时，所有材料沿着斜坡滚动，循环结束。

Design of automatic assembly line for filament winding, cutting, drying and packaging
1. Mainly remove the fiber from the winch, 2 manually pick the fiber, 3 cut the fiber, 4 hang the fiber to dry, 5 sets of plastic are sleeved on the packaging wood grain paper, and 6 cut both ends of the fiber. Baling. Improve efficiency, smooth fiber silk conveniently and reduce material consumption.
Step 1: squeeze the band brake, hold the winding ring and material, and move the scissors to cut the fiber. The fiber head is hung down, the material head is sucked into the collection cylinder by negative pressure suction, and the plastic bag is manually sleeved on the Yellow cylinder shown in the figure.
Step 2: the claw moves to pull the material. After the claw catches the material head, the negative pressure is closed and the holding brake is released.
Step 3: blow the yellow part in the direction of the arrow, straighten out the wire, pull the claw back and move to the position shown in the figure to stop, and manually tie the plastic bag head to the fiber bundle.
Step 4: pull the claw backward, and the winding machine continues to work until all the fiber bundles come out.
Step 5: after completely moving out, cut the three blades and take out two sections of products that meet the requirements. When the claw is released, all materials roll out along the slope, and the cycle ends.